I moved from Marlin to Klipper recently and noticed that each time I power cycle my printer I have to reset the firmware before it starts communicating. Is this normal? Is there any way to automate it? I am running the latest Octoprint alongside Klipper. I use OctoRelay to control my power relays for the printer as well as my lights.
Thanks!
Klipper - Reset Firmware after Power Cycling Printer?
Forum rules
Be kind, patient and respectful. We're all here to learn and share.
Be kind, patient and respectful. We're all here to learn and share.
Klipper - Reset Firmware after Power Cycling Printer?
Regards,
schooner
schooner